squaring up the x/y axis

New Home Forum Troubleshooting squaring up the x/y axis

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 1 month, 3 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #19268
    Profile photo of David
    David
    Participant

    I’ve been searching the forum, and I’ve been looking for a “how to” on squaring up the gantry for even squared cuts. Could someone point me in the right direction or to a walk thru and/or explain the process in steps? Is there a G command I need to run after I get it squared? I forget the process involved. Thanks in advance!!!

    #19395
    Profile photo of vicious1
    vicious1
    Keymaster

    I really need to make a video of this, only take a minute but hard to explain.

    Set the bit where you want to start your cut. Then measure from your x axis rollers to the nearest corner block, both measurements should be as equal as your can possibly get them. Repeat this for the Y axis, double check them all again. Start your cut!

    Bam……Make sense?

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.