Steppers not moving

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Ryan Ryan 10 months, 3 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #16902
    Profile photo of Jean C
    Jean C

    I am still waiting for someone helps me making my MPCNC works because I assemble everything only electronic and softwaresee to install right to make the machine starts to work. Please help me so that to achieve my goal. I have more than one month waiting.

    Thank you,


    Profile photo of Ryan

    Going to need a lot more information than that.

    These things should all be included in your post. It makes it much faster to diagnose problems.

    1) Did you buy everything from here?
    a)If you didn’t or changed some things please don’t leave out any details.
    b)What firmware?

    2) Are you using end stops?
    a)If so please disconnect them.

    3) Are you using all my recommended parts?
    a) If not please list what parts you used.

    4) Include a picture so obvious errors might be spotted.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.