The first cut is the deepest…

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC The first cut is the deepest…

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 5 months, 3 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #15436
    Profile photo of SpaceCoaster
    SpaceCoaster
    Participant

    A successful build of a 36″ x 24″ MPCNC with 3/4″ EMT. Great design and good fun to build.

    The title is an homage to Rod Stewart, apparently the board wasn’t level and the first cut went through the laminate to the wood. I kindof like the highlight effect!

    No problems at all with the build and assembly. The steppers are relatively feeble 48oz but I am running it nice and slow and it works.

    One small issue, the Y axis judders/shakes a bit. Might just be in need of wearing in as I haven’t sanded down the conduit yet.

    Thank you for the massive amount of work that has gone into this design.

    Attachments:
    #15448
    Profile photo of vicious1
    vicious1
    Keymaster

    AWesome, looks good, clean cut!

    Don’t worry about the steppers I used 42’s for the longest and didn’t find a need to switch them, but got a great deal on the 76’s. You should be fine.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.