Tool mount for Dremel 4000?

New Home Forum Getting Started Tool mount for Dremel 4000?

This topic contains 5 replies, has 4 voices, and was last updated by Profile photo of cave cave 2 weeks, 1 day ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #19352
    Profile photo of Jack
    Jack
    Participant

    I am going to use a Dremel 4000. Does it make sense to print the standard Tool Mount or do I have to design one specific? Or is the standard TM a necessary part for the machine and do I have to mount a specific part (for the Dremel) onto the TM?

    And another question:
    In the file folder there are two Pineapple Couplers in different sizes and also two Nutlocks. Which one to use?

    Thanks

    #19387
    Profile photo of Bill
    Bill
    Participant

    Can’t really help with the Dremel, other than to say you will likely need a different mount. I believe it to be smaller in circumference than the Dewalt. The two pineapple couplers handle different sizes of the threaded rod, the two nutlocks handle different nut sizes.

    #19406
    Profile photo of Jack
    Jack
    Participant

    Thanks Bill,

    If I order the bundle electronic parts from Vicious, do I have to take the 5/16 inch pineapple?

    Maybe there is someone out there using a Dremel 4000?

    #19407
    Profile photo of Konstantin Borisov
    Konstantin Borisov
    Participant

    Have no Dremel 4000 but printed this mount: http://www.thingiverse.com/thing:1623409
    It fits ok for my noname chinese ‘dremel’. Hope it will fit your spindle.

    #19408
    Profile photo of Jack
    Jack
    Participant

    Thanks, and I can see the standard Tool Mount is still being used.

    #21362
    Profile photo of cave
    cave
    Participant

    http://www.thingiverse.com/thing:1594625
    MPCNC 525 Dremel 4000 Mount by fyleo

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.