Tube length for feet?

This topic contains 1 reply, has 1 voice, and was last updated by Profile photo of 3dTI 3dTI 1 year, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #4922
    Profile photo of 3dTI
    3dTI
    Participant

    Hi.

    Frame, gantry and middle assembled. I’m now going to position and square up everything before I bolt the whole assembly to the table.

    I have printed the recommended feet, but what length tube do I cut to get roughly the correct height?

    I am using a bowden style extruder with a E3D volcano Hotend, and a makita rt0700cx-roumer.

    Thanks.

    #4933
    Profile photo of 3dTI
    3dTI
    Participant

    Slaps head! Found the recommended tube lengths on the “Assembly” page. After searching all through the forum for a recommended length lol. All setup now with 115mm lengths. If I can bring myself to cut holes in my new work bench I might install longer lengths if required down the track.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.