two for one.

New Home Forum Getting Started two for one.

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Bradley F Bradley F 1 month ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #20740
    Profile photo of Fingerss
    Fingerss
    Participant

    Has anyone set up both router and 3D printing capabilities right from the beginning? What do I need to do differently with regards to wiring?

    #20741
    Profile photo of Bradley F
    Bradley F
    Participant

    A lot of people have their mpcnc’s set up for multiple capabilities.

    To add 3d printing, you will need an extra driver (and if printing pla, a fan as well), remove the T0 resistor and put a Thermistor there, and will also need to add jump wire at the green power plug on the ramps board.

    instructions for adding more power can be found at http://www.vicious1.com/assembly/ramps-wiring/

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.