Upgrading from conduit to vslot

New Home Forum don’t use this one need to sort -Assembly – MPCNC Upgrading from conduit to vslot

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of vicious1 vicious1 9 months, 3 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #9878
    Profile photo of Fernando Topete
    Fernando Topete
    Participant

    I know changing out the conduit for vslots changes the design quite a bit, but I was wondering if I did so, would I still be able to use your firmware if I kept the Nema 17’s on GT2 16 tooth pulleys?

    #9880
    Profile photo of tmelvin
    tmelvin
    Participant

    Yeah the firmware would work fine, if you are running v slot I think you will be able to up the speed/accell rates over what we are using as it would probably be stiffer

    #9905
    Profile photo of vicious1
    vicious1
    Keymaster

    Maybe you could increase the operating speeds, but not max speed. We maxed out the arduino processor, because of the 32nd stepping. Might have to switch back to 16th stepping.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.