Home / Forum / Assembly / Upgrading to the hardware kit to the new middle Z files

Viewing 2 posts - 1 through 2 (of 2 total)
  • Profile photo of AndrewAndrew
    Post count: 0
    #13323 |

    So quick question,
    Been working on my machine slowly for the past 4 months… bought the hardware kit from here on the site. I had printed out all the files, but now I see there’s an update for the middle section.

    Is there a list of new hardware (bolts, screws, etc..) That I’ll need to buy to make the hardware kit purchased from here work? Or does it use all the same parts?


    Profile photo of vicious1vicious1
    Post count: 2639
    #13329 |

    Besides the new plastic parts, you will need a 5″ bolt and four more 2.5″ bolts. While your buying hardware you should get some more 6/32x.75″ screws and nuts for the other mounts, You might have enough but a little bag of these is only about $2.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.