Wobbly middle z

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of pls pls pls pls 9 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #10467
    Profile photo of pls pls
    pls pls
    Participant

    Hey guys,
    I just finished my build! but the quality is terrible. i dont mean that offensively, but something is wrong with my build. the middle gantry is just so wobbly. I think it is a problem with the better middle z model, because the bearings on those are not all touching the conduit running through them, I’m about to start reprinting them, and other ideas would be much apreciated.

    #10485
    Profile photo of vicious1
    vicious1
    Keymaster

    Pictures will help a lot.

    What parts did you print, what size is your conduit, any mods, what filament, any scaling, any warping, what kind of hardware.

    #10487
    Profile photo of pls pls
    pls pls
    Participant

    I actually was able to fix it, but thank you for the quick response, I was using 23.5mm conduit with 25mm middle_z.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.