z axis making terrible sound

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of Erol Erol 10 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #9312
    Profile photo of bradley
    bradley
    Participant

    When my z axis executes a g01 move it seems happy. however about half way through part it the cam will execute a g0 rapid and the machine makes a terrible grinding noise and the z does not move. then it will proceed as normal. I know it isnt the limit of the z limit because Ive double checked using hand jog. how do i change the g0 rapid speed in repertier? or would this be done in estl cam?

    #9314
    Profile photo of bradley
    bradley
    Participant

    I ran it again just as I did the first time and it fixed itself. not sure what went wrong yet because it was never consistent but does anyone know how to change rapid on this machine? might be good to know

    #9329
    Profile photo of vicious1
    vicious1
    Keymaster

    If you are printing it is in the gcode so it is a slicer setting, if you are jogging it around it is a repetier setting.

    #9507
    Profile photo of Erol
    Erol
    Participant

    please check new topic “estlcam z movement problem” in software

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.