Z-axis

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of vicious1 vicious1 1 year, 1 month ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #4351
    Profile photo of Simon
    Simon
    Participant

    Everything was going fine and now my z-axis seems to not want to retract during the print. I am using the dewalt and the kit from the site. In manual control the z-axis will go up and down, but while running the nc file it doesnt ever retract going further and further into the wood. Not sure what to do. I am going to try replacing the stepper driver for the z axis first.

    Any suggestions or similar expiriences. Also my z-nut-lock is doing great. There is no slipping.

    #4353
    Profile photo of Simon
    Simon
    Participant

    I solved the z axis issue it was the coupler. I used a spare from a printer and it works much better. The printed version deteriorated and was slipping. Now all of a sudden my entire machine is freaking out on prints. It is overlapping everything. Wasnt happening before. I replaced all the drivers and tuned them and still no success with that.

    #4362
    Profile photo of vicious1
    vicious1
    Keymaster

    Overlapping sounds like a slicing issue not a hardware or electronic issue. What slicer?

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.