Troubleshooting – MP3DPNew Home › Forum › Mostly Printed 3D Printer -MP3DP › Troubleshooting – MP3DPThis forum contains 33 topics and 209 replies, and was last updated by Ryan 1 week, 3 days ago.Viewing 30 topics - 1 through 30 (of 33 total)1 2 →TopicVoicesPostsFreshness Troubles with the Z axis bearings Started by: thesfreader22 1 week, 3 days ago Ryan Print is too large after stepper driver change Started by: michael26 3 weeks, 2 days ago Ryan Fail Started by: Ryan816 4 weeks, 1 day ago Ryan Y axis wobble Started by: Dan25 2 months ago Dan Stringing Started by: Dan39 2 months, 3 weeks ago Ryan All over the place. Started by: Robert211 3 months ago Robert Help LCD Bug! Started by: Jeffeb344 3 months, 1 week ago BT Another new one… Started by: Bill44 3 months, 1 week ago Barry Extruder always-on fan keeps burning out Started by: DanielP49 4 months, 1 week ago Barry Y bed improvement Started by: David34 5 months, 1 week ago Bill And not so hot Started by: Bill616 5 months, 1 week ago Bill Hot, hot, hot Started by: Bill418 5 months, 1 week ago Bill No voltage on stepper drivers and LED goes on and off Started by: leader010125 6 months, 3 weeks ago leader0101 Stepper which doesn't Started by: Bill34 7 months, 1 week ago Mmmfishtacos MP3DP — How to set up the endstops Started by: leader010155 7 months, 2 weeks ago Bill A new one on me Started by: Bill37 7 months, 3 weeks ago Bill Leaky hotend Started by: Bill37 8 months ago Bill PLA temp issues Started by: Jon Petersen210 8 months ago Ryan extruder cable pinout Started by: Jon Petersen24 8 months, 1 week ago Ryan assembly issue Started by: Jon Petersen12 8 months, 1 week ago Jon Petersen how to print the dxf files Started by: Dave410 8 months, 1 week ago Mmmfishtacos trying to figure out axis \"lag\" Started by: Jon Petersen47 8 months, 1 week ago Ryan Printer not starting at Z Axis zero? Started by: Matt P.311 8 months, 2 weeks ago Ryan What do you do when the smoke comes out? Started by: Bill23 8 months, 2 weeks ago Bill Beginners mistakes? Started by: Bill414 9 months ago Ryan Mechanical issues vibration sounds and stutters Started by: James VanDusen214 9 months, 2 weeks ago Ryan printing from SD Card Started by: Derek P12 9 months, 3 weeks ago Derek P MK8 Extruder Issues Started by: Bryan23 9 months, 3 weeks ago Bryan MP3DP — bottom of arduino getting warm/hot near voltage regulator Started by: leader010137 11 months ago Karel MP3DP — wire managment suggestions/tips Started by: leader010111 11 months, 1 week ago leader0101 Viewing 30 topics - 1 through 30 (of 33 total)1 2 →You must be logged in to create new topics.