Reply To: pipe can not go into printed part of mpcnc

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC pipe can not go into printed part of mpcnc Reply To: pipe can not go into printed part of mpcnc

#10110

Thomas M
Participant

I was having an issue with the long shoulder bolts cracking the print. The layers where parallel to the bolt axis. I sized it with a reamer. As far as the EMT tubes if you put a chamfer on the od of the tubes. (No problem if you have a lathe with a collet chuck) The chamfer makes it easier to push the tube in.