Reply To: First Crown – Z setting



Hi Vicious,
I made my first test with the test logo you in estlcam guide;)
I did it!
I also maintained the endstop … at the end of the process are reset correctly.

The only thing that has remained the same, as you said, is the setting of the G92 X0 Y0 Z0 on the material I have to work or to write,.

what I still do not understand is where to put the “z-op” when the tool moves.
In estlcam the popup asking me the height at the end is the height of my right material?

But if I have the cutter and a 10mm H panel I want to sink 5mm?