Reply To: GRBL for RAMPS 1.4

New Home Forum Software Development GRBL for RAMPS 1.4 Reply To: GRBL for RAMPS 1.4

#10393

Jeffeb3
Participant

I’ve been thinking really hard about buying one of these, which will only run grbl, AFAIK.

http://www.ebay.com/itm/Raspberry-Pi-CNC-Board-Hat-V2-51-GRBL-Compatable-Uses-Pololu-Stepper-Drivers-/271901344091

Then on the pi, you could run bCNC, OctoPrint (if it works with grbl, IDK yet), or this simple web interface: https://github.com/Protoneer/Raspberry-Pi-CNC

Yeah, I’m going to get one, and I’ll let you know how it goes mid-May when it finally arrives 🙂 . My goal would be octoprint, hopefully without doing a large fork like the previous octoprint cnc stuff.