Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

New Home Forum Software Development Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

#10828

Leo69
Participant

I think you’re posting on the wrong forum.i doubt anyone here has that engraver or knows the function of the jumper you mentioned. Laser pwm control is dependent not only on the microcontroller and firmware but also the laser driver.If the driver doesn’t accept ttl/pwm control signal then grayscale raster engraving can’t be done. I just browsed through a couple of listings for this machine and the specs are very poorly documented. I think you have your work cut out for you.