Reply To: pipe can not go into printed part of mpcnc

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC pipe can not go into printed part of mpcnc Reply To: pipe can not go into printed part of mpcnc

#11152

Jeffeb3
Participant

Yeah, I tapped mine with a persuader (hammer) too in some places. I think tight is better than loose, because the PLA isn’t going to get any tighter.

Basically what I’m saying is that I was skeptical, but used a hammer anyway, because if I needed to reprint it, I might as well start by breaking the old one. In the end though, I think that’s the perfect fit.