Reply To: Estecam tool changes, or tool changes in general?

New Home Forum Software Development Estecam tool changes, or tool changes in general? Reply To: Estecam tool changes, or tool changes in general?

#11273

Barry
Participant

I’ve run into this as well. That’s the way I’d do it, but haven’t tried it yet. I do know you’ll need to edit the gcode to remove the pause and tool change commands. It freaks out repitier. Hardest part will be keeping x and y in position. I’ve been starting with the bit touching the board, so I usually have a small divit to work off of.