Reply To: Using MPCNC Only as a CNC machine, which controlling software is best for this?

New Home Forum Software Development Using MPCNC Only as a CNC machine, which controlling software is best for this? Reply To: Using MPCNC Only as a CNC machine, which controlling software is best for this?

#12052

Leo69
Participant

I was going to suggest Mach3 or Linux CNC but neither support arduino. Grbl is good for a no frills setup and will support the Uno board as Well the Estlcam firmware mentioned in last post.That will be good enough for most any project you can think of.

If you’re interested in other features Like integrated camera support, support for mpg pendants, native 4th axis support, point cloud probing support, 3d scanning with camera, canned drill cycles for better pcb support, etc…. then consider an upgrade;)