Reply To: Updated Center Parts

New Home Forum Updates Updated Center Parts Reply To: Updated Center Parts

#12730

EMC75
Participant

Been working with the new center for over a week now and the only issue I have had is that the center became looser after a couple days of use.
I had to tighten all the bolts to get the bearings to touch the pipe again. I don’t think it will go any tighter so I might reprint it at 99.5% in the future.

After this everything has been fine. Been doing mostly cuts in MDF, created a new t-slot and spoil board and so far it has been good.

Now I need to figure out a dust shoe as my garage is covered in dust. The old dust shoe no longer fits because of the new mount 🙂