Reply To: File extensions in repetier

New Home Forum Software Development File extensions in repetier Reply To: File extensions in repetier



Thank you so much. Still can’t see them to resize in repeater but if I resize the snot out of it in estelcam and save it as a .gcode it will load to print preview.. Any ideas as to why it won’t show up in object placement? It will switch to print preview and i can print or (write it with a pen)but Not able to resize in repeater. The board goes blank when you switch back to object placemant tab… Thoughts or suggestions? N thank you again for the help, I never would’ve seen it that small.. I looked, it had to be under the dot….