Reply To: Firmware

New Home Forum Software Development Firmware Reply To: Firmware

#13712

Silvio Franco
Participant

Hi, keymaster. Excuse me but I have a couple of questions in addition to the prior post I sent you yesterday.

1. When I launch my Arduino I see the attached print screen info. Also the following parameters:
/**
* About Marlin
*
* This firmware is a mashup between Sprinter and grbl.
* – https://github.com/kliment/Sprinter
* – https://github.com/simen/grbl/tree
*
* It has preliminary support for Matthew Roberts advance algorithm
* – http://reprap.org/pipermail/reprap-dev/2011-May/003323.html
*/

/* All the implementation is done in *.cpp files to get better compatibility with avr-gcc without the Arduino IDE */
/* Use this file to help the Arduino IDE find which Arduino libraries are needed and to keep documentation on GCode */

#include “Configuration.h”
#include “pins.h”

#if ENABLED(ULTRA_LCD)
#if ENABLED(LCD_I2C_TYPE_PCF8575)
#include <Wire.h>
#include <LiquidCrystal_I2C.h>
#elif ENABLED(LCD_I2C_TYPE_MCP23017) || ENABLED(LCD_I2C_TYPE_MCP23008)
#include <Wire.h>
#include <LiquidTWI2.h>
#elif ENABLED(LCM1602)
#include <Wire.h>
#include <LCD.h>
#include <LiquidCrystal_I2C.h>
#elif ENABLED(DOGLCD)
#include <U8glib.h> // library for graphics LCD by Oli Kraus (https://github.com/olikraus/U8glib_Arduino)
#else
#include <LiquidCrystal.h> // library for character LCD
#endif
#endif

#if HAS_DIGIPOTSS
#include <SPI.h>
#endif

#if ENABLED(DIGIPOT_I2C)
#include <Wire.h>
#endif

#if ENABLED(HAVE_TMCDRIVER)
#include <SPI.h>
#include <TMC26XStepper.h>
#endif

#if ENABLED(HAVE_L6470DRIVER)
#include <SPI.h>
#include <L6470.h>
#endif

2. Just to confirm, is there some additional config that I need to have in my Arduino.

3. Sorry, but I am a rookie in this subject. I appreciate your help. Thank you very much

Attachments: