Reply To: Two bearings loose on the middle assembly

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Two bearings loose on the middle assembly Reply To: Two bearings loose on the middle assembly

#13956

Rui
Participant

No, because, I haven’t the bottom piece(std tool mount), since was doing the multi extruder one.

At bottom is using a copy of the lower Z mount for testing. But, what is strange, is that is the same hole, since the pieces are installed mirrored. Its ABS and the outmost Z bearings flex a little when inserting the Z assembly.

But is solid as a rock. I could say ABS is usable for MPCNC but tricky to print and smells bad… lots of acetone slurry 😀

It’s a lovely toy U gave us Vicious!