Reply To: Chinese 5mW red line laser – driver/heatsink?

New Home Forum Mostly Printed CNC – MPCNC Hardware Development – MPCNC Chinese 5mW red line laser – driver/heatsink? Reply To: Chinese 5mW red line laser – driver/heatsink?

#14099

Leo69
Participant

I see the 5v source voltage is listed but What’s the input current? I’m guessing approximately 40-50ma. If so, no driver should be needed.you can connect directly to an unused digital pin on Ramps board and switch/power the diode through a marlin m42 command.