Reply To: Increasing feed rate between cuts in Estlcam (or Repetier)

New Home Forum Software Development Increasing feed rate between cuts in Estlcam (or Repetier) Reply To: Increasing feed rate between cuts in Estlcam (or Repetier)

#14194

RAGII
Participant

Thanks vicious,

I just found that and was going to post it so thanks for confirming my thought. If I understand the value correctly I multiply the desired mm/s by 60 to get the feed rate. (20 mm/s x 60 = 1200).

Didier, I just opened my G code in notepad, searched for 1200, and replaced my Z only moves with a different value to get XY moves at a different rapid rate than the Z moves. Took me all of 2 minutes to go through my program and do this. Was actually pretty easy.

Attachments: