Reply To: Increasing feed rate between cuts in Estlcam (or Repetier)

New Home Forum Software Development Increasing feed rate between cuts in Estlcam (or Repetier) Reply To: Increasing feed rate between cuts in Estlcam (or Repetier)

#14213

Didier
Participant

@ragii Thanks, I was thinking to do that but my idea is to avoid to edit gcode, for serial works or moments when you just want to click and play 🙂 Actually you are right this is the way (for those who want to do that check the box “repeat” under F section). But my travel moves are 2700mm/min (45mm/s) (my Z max speed) and it is quite good for this moment. And so you are right for the value to write, it is mm/min.