Reply To: Milled/printed Prusa Style Printer

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC Milled/printed Prusa Style Printer Reply To: Milled/printed Prusa Style Printer



Wow Thanks!

I will have a run through next time I build one.

The aluminum beds must have different holes than the PCB ones I have on mine. I didn’t bother to check, it should’ve been standard…my bad for assuming.

The extra holes I just pop through by hand they are needed in different places on both my printers, but maybe I can make it a little different.

I did raise the ramps up as far as I could go to use the same holes for the ramps and power supply. I could make these different parts I guess.

What size steppers are you running, mine are barely warm (the ones from the cnc kit)?

I should mark the bed holes for sure, I have screwed that up myself.