Reply To: Tin's 1100x900mm Build

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC Tin's 1100x900mm Build Reply To: Tin's 1100x900mm Build

#15915

Martin S
Participant


After removing the 4 screws that hold the cover you see this beauty. They should make the plastic cover cristal clear, it’s incredible the way everything its arranged. I’ve used 1mm silicone cable, the same as stock. For the rail section 1.5mm just in case.


Done! with XT60 connector installed. The old wiring was removed and could be installed if I need to send the router to service or sell it.


Quick disconnect at the end of the cable chain. Good to do if you want to plug other things than the router.

That’s all, I hope it helps someone else with the build.
Tomorrow I’m buying some bits and will start doing some cuts or engravings.