Reply To: Repetier connection setup info?

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Repetier connection setup info? Reply To: Repetier connection setup info?

#16194

Benjamin Shaw
Participant

At the moment yes, I’m not sure where I got that from. Maybe it was because I did a bunch of Fusion 360 tutorials and they always set zero at top left of part. I think I saw youtube videos of this as well.

Looking at your rendering, I see it would be in the upper right corner? Is there a preferred position for zero?

EDIT: Was just messing around with settings and I got the origin dot to go to the top left by setting the bed front parameter to be equal to the bed depth. Not sure if this will mess anything else up till I can test tonight.