Reply To: I'm New! – Z axis and extruder working but x/y won't move

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC I'm New! – Z axis and extruder working but x/y won't move Reply To: I'm New! – Z axis and extruder working but x/y won't move

#16405

Troy Proffitt
Participant

Checked jumpers under x/y drivers and they are fine (pic attached). Replaced power supply and monitored voltage on driver when z motor was running and it doesn’t sag at all. Re-flashed marlin firmware and moved baud rate to 115200. None of this seems to make any difference