Reply To: Motors not moving and driver issues

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Motors not moving and driver issues Reply To: Motors not moving and driver issues

#16709

Jason
Participant

Did not have resistor plugged in. My bad. Plugged it in. Still no action.

This is a PC Win 7. Baud rate set to 115200.

I’ve previously used Repetier a few times but have preferred slic3r for slicing my print files and then I print from the lcd RepRapDiscount Smart Controller. Is your firmware setup for lcd? Can I plug it in and control directly from that?