Reply To: If you water them they grow!

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC If you water them they grow! Reply To: If you water them they grow!

#16917

Barry
Participant

Crap, that’s not going to work. Oh, well, I guess for that project I’ll just not have the dust collection on. The cat-5 cable that’s hanging is for the Z, it’s too short… So the pauses are where the router should be dropping a mm. I’m running it at 250% speed, so it’s going faster than it would be if it was cutting. Though this part will be some of that Menards hdpe, so I probably could cut at that speed!