Reply To: Abs build

#17062

johan
Participant

The printer heats up the chamber in the half an hour pre heating.
I have a 60x60mm fan running 5 volt sucking out the fumes through a old vacuumhose out of the window.
I am planning on using a arduino to control the fan so the temperature gets a bit more stable.

Box is made out of 12mm MDF and 55x55x55 cm inside measurement.
Filament holder sits on top of the box.
Still need to cut out the holes for the acrylic, have been printing to much and no time to do it đŸ˜‰