Reply To: Settings for using Estlcam as controller software?

New Home Forum Software Development Settings for using Estlcam as controller software? Reply To: Settings for using Estlcam as controller software?

#17868

Markus Hauser
Participant

So basic setup, all based on calculation:
X/Y
6400 steps per turn (1.8° = 200 Steps 1/32 = 6400)
32mm per turn (16 teeth 2mm pitch GT2 belt)
30mm/s max. speed (more cant be computed due to 160 kHz limit of Arduino Uno)
Z
6400 steps per turn (1.8° = 200 Steps 1/32 = 6400)
1.25mm per turn (M8 screw)
8.5mm/s

When my machine is fully wired i will test these and reply.