Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Development Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#17982

Juergen Schilling
Participant

Yah, the GRBL should be the right one for CNC shield V3.00… So the end stops are as printed on the board and the probe input can be found as SCL on the I2C connector, and spindle control is an SpnEn… ­čÖé
Now, everything is clear for wiring the CNC shield to my MPCNC…

Thanks,
Juergen