Reply To: Gantry Rail Height – Y-Axis Rail slightly above rollers

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Gantry Rail Height – Y-Axis Rail slightly above rollers Reply To: Gantry Rail Height – Y-Axis Rail slightly above rollers

#18034
Profile photo of Ryan
Ryan
Keymaster

If your spacers printed poorly they could cause that. In that case either reprint them or sand them down a bit.

There is no way to measure the spacers, two opposite circular cuts.

Gap is a few mm, like you said so you can clamp it.