Reply To: Recommended case for ramps and full graphic card?

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Recommended case for ramps and full graphic card? Reply To: Recommended case for ramps and full graphic card?

#18484
Profile photo of P3DCNC
P3DCNC
Participant

Is there something special about the ramps board from you guys? It seems that most cases I’ve tried, the power connector is in the wrong location. It’s a little too far to the outside edge of the board (to the right when looking at the connector).

Just wondering..