Reply To: Perfect built at last (after a lot of tuning) – oval circles and rectangulars

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Perfect built at last (after a lot of tuning) – oval circles and rectangulars Reply To: Perfect built at last (after a lot of tuning) – oval circles and rectangulars

#19127

Ryan
Keymaster

Marlin Firmware

What were your settings for speeds and travel speeds? What software, are you sure you imported it correctly and didn’t scale it.

Maybe try just a large square. Are you trying the same file over and over again? This could be a software CAM issue, or a speed issue, or a driver issue. The cable ties are rated to more than 40lbs, If you put anywhere near that on the belt you are going to stall the steppers.