Reply To: Retraction – Repeier irmware or slic3r?

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Retraction – Repeier irmware or slic3r? Reply To: Retraction – Repeier irmware or slic3r?

#19172

James Donnelly
Participant

I am using Repetier Firmware, which I have tonight discovered has retraction enabled by default.

Slic3r is bundled with Repetier Host, and in this instance also comes with default settings of retraction on.

If they are both operating, then this would be strange as this means anyone who downloads Repetier firmware and host will have doubled up settings.

I will raise a question about this on the Repetier forums (I started asking all my questions here because I am getting the right answers quickly).

Thanks.