Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Development Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#19785

Christoph Egli
Participant

Hello at all

first, im from switzerland and my english is pretty bad šŸ™‚

i have a problem with getting estlcam and ramps to work

when i try to upload marlin from vicious1 on my all brand new iduino mega with a i believe its a ultimachine ramps 1.4 board and 5 (chinese) drv8825 drivers i have no problems

but when i try to upload the firmware with estlcam i get the message in german “aktiviere bootloader: fehlgeschlagen” wich in english probally means, activate bootloader: Failure

i removed the ramps shield and tried it again, everything works perfect until i connenct the shield, then i get a message from estlcam that it is not getting an answer from the arduino

does anyone here has the same problem or probally has a solution to me?

thank you very much