Reply To: My Adventures with the MPCNC

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC My Adventures with the MPCNC Reply To: My Adventures with the MPCNC

#19794

Dave B.
Participant

Haha, it didn’t last long in this position/state. I was given orders to remove it before Thanksgiving even though I told her the laser could cook the turkey then the Dewalt could carve it perfectly! It’s now in the garage on a proper table.

Here’s the current state of affairs; still need to do up an electronics enclosure and figure out my workpiece clamping. Thinking about the drag chains to keep wires clean and need to 3d print a Frickin Shark to hold the Frickin laser beam!

Attachments: