Reply To: X/Y Jitter, Middle Assmbly Problems

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC X/Y Jitter, Middle Assmbly Problems Reply To: X/Y Jitter, Middle Assmbly Problems

#19798

Nathan
Participant

Pulled the motor mounts, checked the frame everything in the outer rails are square and parallel.

The rollers have all worked loose, I have attached a video below. At time of install they were all tensioned the same and were snug on the rails. What would be the best way to snug these up again?

Also it do look like the middle is out of square. What would be the best tension bolts to adjust this?