Reply To: X/Y Jitter, Middle Assmbly Problems

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC X/Y Jitter, Middle Assmbly Problems Reply To: X/Y Jitter, Middle Assmbly Problems

#19891

Nathan
Participant

There was a little play on one axis so I tighten the tension bolt and the play is gone. But then it seems as if it is not square and fighting itself. I did check the z and there is a little play when the axis is don about 5 inch but anything above 3 and the there is no play. So that is causing my problem now as I have the work piece raised.

What would be the best way to correct this?

I was thinking that if I loosen all tension bolts with the assembly on the machine should be able to use the motors to help keep the assembly square while I retighten the tension bolts. Also should all tension bolts including the 5″, get snugged up after teverything is square?