Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

New Home Forum Software Development Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

#19936

Leo69
Participant

The sender software you’re using was developed by Villamany for GRBL based laser engraver running on Arduino Uno board. We’ve modified that software to run on Mega2560/Marlin based hardware. You’re not providing enough information about your hardware for me to even guess what the problem is.What exactly is the error message? What firmware and hardware do you use? What command activates your laser? I recommend posting your question on the 3dpburner site for a quicker response.