Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Development Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#19969

Juergen Schilling
Participant

Hi Guys,

I’m currently facing some problems with the sense input… I’ve wired a long ground wire to the shaft of my Kress router. The sense input is wired to a tool length touch plate and to a connector box. When I don’t have any filtering, the sense input will be triggered, when I switch on the Kress router…

So I’ve followed the suggestion in Estlcam and added a 1kOhm resistor and a 100nF capacitor. Now it will not trigger the sense input, when I’m switching on the Kress. But, while the milling job is running, sometimes it happens again, that the sense input will be triggered and the machine stops.

When I unplug the sense input completely, everything works fine and the job will never stop.

Does someone had the same experiences?

I’m thinking about applying a 4.7kOhm resistor and a 330nF capacitor…

Cheers,
Juergen