Reply To: My Adventures with the MPCNC

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC My Adventures with the MPCNC Reply To: My Adventures with the MPCNC

#19970

Dave B.
Participant

No shark yet, but some progress. I snagged a Ramps Enclosure from Thingiverse and modded it, needed to cut out near the printer port and power input after the fact as the kit was slightly different. I’d likely split the black pieces into 2 if I was going to print it again.

Today’s mission is to try to get the MPCNC to draw a picture. I mounted the ‘Spring Loaded Pencil Holder’ and just need to figure out how to make the code. Hopefully back soon with some results!