Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

New Home Forum Software Development Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

#20066

Leo69
Participant

As I mentioned before, the sender software that you’re using is not supported here.No one on this forum uses it because it is created specifically for the 3dpburner laser engraver/Grbl. The version of image2gcode that’s hosted here is modified to run on Marlin firmware and not Grbl. If you’re running Grbl then I recommend going to the 3dpburner site that I linked earlier for support.