Reply To: My Adventures with the MPCNC

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC My Adventures with the MPCNC Reply To: My Adventures with the MPCNC

#20135

Dave B.
Participant

To answer your question (that I missed), the laser and small board are from here; https://sites.google.com/site/dtrlpf/home/diodes/6w-nubm44-445nm-laser-diode
and the larger Optlaser board is from Optlaser.com

I also tried a second time to cut with the CNC and found it wasn’t a code issue but my Z-Axis was binding which caused it to raise but not fully lower. Loosened the coupler from the bearing up top and greased the leadscrew and away she went.

Burning wood on this one as I’m using a drill bit, but I put in an order for some real end mills so more to come. Now to focus on the Laser.