New Home › Forum › Mostly Printed CNC – MPCNC › Troubleshooting – MPCNC › Stepper gone mad (Video) – Is this a driver, the ramps board, or the arduino? › Reply To: Stepper gone mad (Video) – Is this a driver, the ramps board, or the arduino?
Hi Wesley, I’d been trying accels under 40mm/S^2, and feeds of 400mm/min to 200 mm/min, as in G1 Z30 F200, as well as repetier commands.
Big update, I screwed up the wiring! Used some M-F dupont wires to swap it back, and apparently I should have left well enough alone! Now it’s time to slap it into the center and get dusty! Thanks again, helpful friends!
Enjoy your feasts!