New Home › Forum › Mostly Printed CNC – MPCNC › Your Builds – MPCNC › IT LIVES!!! Another one built – Melbourne Australia › Reply To: IT LIVES!!! Another one built – Melbourne Australia
M8 bolts fit fine, just quickly run a 8mm drill bit through the hole to knock the printed edge off to a smooth surface and the m8 bolt slides straight through. I’m using stainless button cap bolts for mine 🙂
I’m also using the Bunnings 25.4 Gal tubing, seems to be pretty good. Profile is not absolutely perfect through the entire length however no tubing is and it’s close enough that the rollers seem to roll on it well enough, i’m sure they will be even better once the bearings tram themselves out on their running line.